ADTRAN Octal BRI S/T, Руководство пользователя

Страница: 36 / 40

Appendix A. Dial Plan Interface Configuration
36 Octal BRI S/T User Manual 61200343L1-1
OCTAL BRI S/T MODULE INTERFACE CONFIGURATION
This section describes the network and user termination configuration set-
tings for the Octal BRI S/T Module when using the
D
IAL
P
LAN
menus. The
following configurations are provided here:
• Octal BRI S/T Module: User Termination on page A-36
OCTAL BRI S/T MODULE INTERFACE JUMPER SETTINGS
The Octal BRI S/T Module interfaces provide the capability to individually
configure both the terminal resistance and line power using two sets of
jumpers located on the module board behind the port interfaces.
T
ERMINAL
R
ESISTANCE
(T
ERM
R
ES
)
By default the terminal resistance for each port of the Octal BRI S/T Module
is set at 100
Ω
. For this configuration, both jumpers labeled T
ERM
R
ES
must
be in the O
N
position (the O
FF
pin left uncovered).
Figure A-2. Terminal Resistance (100
Ω
) Jumper Configuration
OCTAL BRI S/T MODULE: USER TERMINATION
The Octal BRI S/T Module acts like the network while interfacing to user
equipment (terminal adapters). When you are working in the network ter-
mination section of the
D
IAL
P
LAN
menu and S
LT
is defined as a S/T BRI
module, the following interface configuration options are available:
ADTRAN does not recommend changing the Terminal Resistance
jumpers to the
O
FF
position.
000029P 000 029 P
APC14103E APC 141 03E
P1 P1
P3 P3 RES
RES
PORT 1 PORT 1
ON ON OFF OFF
TERM TERM
P1 P1
P3 P3 PWR
PWR
PORT 1 PORT 1 ON ON OFF OFF
PS1 PS1
Using the Octal BRI S/T Module on a User Term endpoint requires the
use of a straight through ISDN S/T cable.