job
Aid
1
D
ESCRIPTION
The OC-48/STM-16 DWDM 1560.61nm 80 km SFP (DWDM SFP)
is a full duplex serial electric, serial optic device with both
transmit and receive functions contained in a single module that
provides a high speed serial link at SONET OC-3, OC-12, OC-48,
SDH STM-1, STM-4, STM-16, and GigE rates. The DWDM SFP
operates on Optical Channel 21 (1560.61 nm). When installed in
the appropriate host module, the DWDM SFP provides an optical
interface to the supporting system.
The transmit side of the DWDM SFP converts serial NRZ
electrical data at the line rate to a standard compliant optical
signal. The receive side converts the incoming DC balanced serial
NRZ optical data at the line rate into serial electrical data.
NOTE
To ensure compatibility, refer to the documentation provided
with the host module.
The DWDM SFP supports the following features:
•
1560.61 nm optical signals for up to 80 km reach
•
Low power consumption (<1.5 W max)
•
Bit error rate 10^–12
CAUTION
!
Due to compliance certification requirements, use only SFPs/
XFPs supplied by ADTRAN with the host module. ADTRAN
cannot certify system integrity with other SFP/XFPs.
Small Form-Factor Pluggable
OC-48/STM-16 DWDM 1560.61nm 80 km SFP
O
PERATIONAL
S
PECIFICATIONS
•
Channel Spacing: 100 GHz
•
Data Rate: 150 Mbps to 2.5 Gbps
•
Optical distance: 80 km nominal
•
Transmit Wavelength: 1560.61 nm (Channel 21)
•
Receive Wavelength: 1525 nm to 1565 nm
•
Optical transmit levels: 0.0 dBm to +5.0 dBm
•
Spectral Width: 0.4 nm (20 dB spectral width)
•
Extinction Ratio: 8.2 dB
•
Optical receive level: –29.0 to –8.0 dBm
•
Receiver Damage Threshold: –5.0 dBm
•
Optical Path Penalty: 2.0 dB max
•
Minimum Span Attenuation: 13 dB
•
Optical Budget: –27 dB
•
Dispersion Tolerance: 1600 ps/nm
•
Optical connectors: LC
•
Environmental Support:
o
Operational temperature range: –40°C to +65°C
o
Storage temperature range: –40°C to +85°C
o
Relative humidity: up to 85%, noncondensing
I
NSTALLATION
To install the DWDM SFP into an appropriate module, complete
the following steps:
1. Inspect the DWDM SFP. If damaged, file a claim with the
carrier and then contact ADTRAN Customer Support.
CAUTION
!
Do not remove the protective end cap from the SFP until the fiber
optic cable is ready to be connected.
2. Insert the DWDM SFP into the SFP cage on the module.
Ensure that the manufacturer label on the SFP is facing
upward for correct installation.
3. Slide the DWDM SFP all the way into the receptacle until
there is an audible “click.”
NOTE
Use the latch on the DWDM SFP to remove the SFP from the SFP
cage mounted on the printed circuit board.
CLEI: SOOTALVJ__
Product P/N: 1442707G1
Issue Date: October 2011
Document P/N: 61442707G1-22A
