Integrating ADTRAN eSBC and NEC SV8100
Configuring the NEC SV8100
6AOSSG0027-42A
Copyright © 2015 ADTRAN, Inc.
14
Step 4: Configuring a SIP Trunk Group
Once you have established communication with the NEC SV8100, create a SIP trunk group with four
unassigned trunks. The trunks used for the trunk group should not be the trunks already in use for the
central office (CO) or the Primary Rate Interface (PRI) (i.e., trunks
1
through
28
).
Trunk groups can be configured in either the
Standard
view or
System Data
view.
To access the trunk
group configuration from the
Standard
view, select the
Standard
tab in the bottom left corner of the
PCPro main menu, then select
Trunk Groups
from the
Standard
pane. To access the trunk group
configuration from the
System Data
view, select the
System Data
tab in the bottom left corner of the
PCPro main menu, then select
14-XX: Trunk Setup > 14-05: Trunk Groups
from the
System Data
pane.
Refer to the
Univerge SV8100 PC Programming Manual
available from NEC for configuration details.
Step 5: Configuring the SV8100 System Data Settings
Use the following sections to configure various SV8100 settings using the
System Data
view.
Allocating the SIP Trunk Ports (10-03: IPL Configuration)
To allocate physical trunk ports to logical trunk ports and assign the trunks a trunk type, follow these steps:
1. Select the
System Data
tab, then select
10-XX: Trunk Setup > 10-03: IPL Configuration
from the
System Data
pane. The
10-03: IPL Configuration
menu will appear.
2. In the
10-03: IPL Configuration
menu, allocate physical ports for each SIP trunk configured on the
SV8100 (i.e.,
29, 30, 31, 32
):
