831-t5 Mesh AP QSG
Safety and Regulatory
6SDG831T5-13A
5
Safety and Regulatory
Regulatory Compliance
This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation
of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against
the end-user by the applicable National regulatory authority.
This product's firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all options described in this
user's guide may not be available in your version of the product.
Europe – EU Declaration of Conformity
Products bearing the marking comply with the following EU directives:
■ EMC Directive 2014/30/EU
■ Low Voltage Directive 2014/35/EU
■ WEEE Directive reference: 2012/19/EU
If this product has telecommunications functionality, it also complies with the requirements of the following EU Directive:
■ RED 2014/53/EU
Compliance with these directives implies conformity to harmonized European standards that are noted in the EU Declaration of Conformity.
For indoor use only. Valid in all EU member states, EFTA states, and Switzerland.
This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP
in the frequency range of 2454 - 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.
FCC Requirements for Operation in the United States
FCC Information to User
This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifi
-
cations will invalidate all applicable regulatory certifications and approvals.
FCC Guidelines for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance of 25 cm between the radiator and your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures.
FCC Declaration of Conformity
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
■ This device may not cause harmful interference, and
■ This device must accept any interference received, including interference that may cause undesired operation.
CAUTION!
f
■
Connect the DC power input to an approved Limited Power Source (LPS) power supply ONLY.
■
This product is intended to operate in ambient temperatures up to 40°C.
■
It is recommended that an external AC Surge Protection Device be installed at the AC input connection to the local AC-Powered
product. The Surge Protection device should provide L-N, L-G, and N-G protection. It is also recommended that the device
contains a visual 'GOOD' indicator.
■ The product is intended for indoor use only. Ethernet, Voice, and attached equipment are intended for use within the same
building with equipotential bonding, and not intended to be placed in separate buildings or structures. Failure to deploy as
described could result in permanent damage from lightning or other electrical events and voids the warranty.
NOTE
g
This product meets the following compliance requirements:
■ This equipment contains no parts that can be serviced by the user.
■ This product meets EU RoHS Directive. Refer to www.adtran.com/environmental for further information on RoHS/WEEE.
■ This product is NRTL Safety Listed to the applicable UL/CSA Standards.
■ This product has also been evaluated to applicable international standards as indicated by CE, UKCA, and RCM markings.
■ The AC branch circuit socket-outlet must be installed near the equipment and must be easily accessible.
■ The RJ-45 jacks are not used for telephone line connection.
