OPC7000 series
14
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
3.1 Operating location
The control system is designed for use inside a switching cabinet. Make certain that the specified
environmental conditions are maintained at all times. Use in non-specified environments, i.e., on board
ships, in explosive atmospheres or at extreme elevations, is prohibited.
ATTENTION
Hazard due to condensation
Damage to electronic components caused by
condensation resulting from temperature
fluctuations.
The device should only be switched on after it
has acclimated to the ambient temperature!
To avoid overheating in operation: The device
must not be exposed to direct radiation by
sunlight or any other heat source.
3.2 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
3.3 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or by
service personnel that has been authorised by the manufacturer.
