Admesy MSE Series, Руководство по эксплуатации

Страница: 14 / 25

14
5.7 User EEPROM commands
Table 10 shows the commands which can be used to store values in the
user EEPROM space. It is advised to reboot the MSE after writing new
values to the EEPROM.
Command syntax Parameters Range Purpose
:EEPROM:
STARTUP:READ None Copies startup
conditions from
EEPROM to internal
variables.
Values can then be
read using
:SENSe:AVERage? for
example
:EEPROM:
STARTUP:WRITE MSE mode
Integration
time 0
– 5
100
–
5000000
Copies internal
variables to EEPROM
and sets mode and
amp factor
:EEPROM:
SBW:READ User matrix
Index 1
Index 2 0
– 29
0
– 2
0
– 2
Read user calibration
matrix
:EEPROM:
SBW:WRITE User matrix
Index 1
Index 2
Value 0
– 29
0
– 2
0
– 2
Float
Write user calibration
matrix
:EEPROM:
READ:SN None Read serial number
:EEPROM:
READ:SBWNAME Matrix
number 0
– 29
Read name of matrix
:EEPROM:
WRITE:ID Device ID 1
– 255
Device ID can be used
to link to a mechanical
position and read back
in software so the
position is linked with
the measurement data
:EEPROM:
READ:ID Read device ID
:EEPROM:WRITE Write all settings to
EEPROM
Table 10 User EEPROM commands.