23
HPERC-KBL-M
2.8 Powering Up the HPERC-KBL-M
Apply power to the HPERC-KBL-M
X
Connect the AC Mating Cable to the AC Adapter (see Figure 1-2).
X
Plug in the DC Cable Connector from the AC Adapter to the DC IN jack on the
HPERC-KBL-M. See Figure 2-4.
X
Plug in the VGA or LCD monitor’s power cord to an AC outlet and turn on the monitor.
X
Plug in the AC Mating cable to an AC outlet.
X
Press the HPERC-KBL-M Power On button on the breakout cable to power on the
HPERC-KBL-M.
Verify the HPERC-KBL-M powers on properly
X
To enter the BIOS Setup, press the <Del> key during power-on self test (POST).
X
Use BIOS Setup during the initial boot to set the desired options.
X
You should see POST complete successfully before the system starts loading the operat-
ing system (optional). If you are using Linux, the boot loader will appear first, similar to the
one shown below with the corresponding OS name displayed.
Using the Operating System
X
You should see a prompt on the monitor screen indicating the OS is loading, or has loaded.
X
Refer to the respective OS manual (not supplied by ADLINK).
CAUTION:
Power supplied to the unit must be within 18-36VDC.
Failure to provide proper power may damage the system and void the
warranty.
GNU GRUB version 0.xx (xxxk lower/xxxxxx upper memory)
Linux Kernel 2.6.x-xxx (recovery mode)
Use the
and
keys to select which entry is highlighted.
Press Enter to boot the selected OS, ‘e’ to edit the
commands before booting, ‘a’ to modify the kernel
arguments before booting, or ‘c’ for a command-line.
(The Linux x.x OS is shown as an example.)
