Adeunis RF LoRaWAN 915 FTD, Руководство пользователя, Страница: 17 / 35

LoRaWAN 915 FTD – User guide version 1.0
Page 17 / 35
2.2 Using the FTD
2.2.1 Default configuration
The demonstrator is pre-configured at factory with the following default settings:
Parameter Configuration
Activation mode OTAA (Over The Air Activation)
DEVEUI
Factory set
Format = 0018B2xxxxxxxxxx
APPEUI Factory set
APPKEY Factory set
Device Address 0x00
Accelerometer Activated
T°C sensor Activated
GPS Activated
Communications tables/channels US table (module tables 0 / 3 / 5)
RX2 Configuration 923.3 MHz / DR8
TX periodicity 20 s
ACK Mode unconfirmed
2.2.2 Powering up the device
Power–ON the device by sliding the ON-OFF switch to the right. This should power ON the LCD screen
Power–OFF the device by sliding the ON-OFF switch to the left. This should power OFF the LCD screen
2.2.3 Join procedure
If the device is in OTAA mode, it will automatically execute a Join process at power-ON.
Note: In ABP mode, there is no Join procedure. All keys are entered manually by the user
2.2.4 Sending a frame
There are two ways to send a radio frame
- By default, the device is configured to send RF frames automatically and periodically
- Pressing BTN1 will trigger a manual frame transmission
2.2.5 Accelerometer
An accelerometer is available in the device. Shaking the device will trigger a “LinkCheck request”. See 3.3.9 for configuration
options.
2.2.6 GPS
A high performance GPS is available in the device. When available, GPS coordinates are included in the transmission frame to
allow device geolocation. See 3.3.10 for configuration options.