Please read and save these instructions:
ASSEMBLY INSTRUCTIONS
Be careful when unpacking the lamp since the wires are
connected. If the wires are pulled out of their connectors, it may
result in a bad connection.
ASSEMBLY INSTRUCTIONS
3 PIECE BONUS PACK #1584-15
Floor Lamp
1. Carefully unpack and place all parts on a soft, flat surface.
2. Insert tube (B) into lamp base (A), gently twist to tighten.
3. Insert tube (C) into tube (B), twist to tighten.
4. Insert tube (D) into tube (C), twist to tighten.
5. Insert socket assembly (E) into tube (D), twist to tighten. Gently
pull any excess cord from the lamp base.
6. Place harp (G) onto saddle (F).
7. To assemble shade, place the support rod into bottom ring as
shown in diagram. Place the other end of the support into the top
ring. Repeat this step with the other rods.
8. Place shade (H) onto harp (G) and fasten with finial (I).
9 Use with one
150 watt max
standard bulb or 3-way CFL
IMPORTANT SAFETY INSTRUCTIONS
Many people are choosing to use energy efficient CFL light bulbs.
This portable lamp has a polarized plug (one blade is wider than the other) as a safety feature to
Some CFL bulbs may change the functionality of the lamp.
reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does
For example: if this lamp has a low/high/off function or 3-way switch,
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never
then when using the CFL bulb on the low setting the bulb may either
use with an extension cord unless plug can be fully inserted. Do not alter the plug. Indoor use only.
flicker or not work. We recommend only using at the “high” level.
Indoor use only in dry location
9. Use with one
150 watt max
standard bulb or 3-way CFL
equivalent. Do not exceed maximum wattage as specified on the
socket label.
Table Lamp
1.Carefully unpack and place all parts on a soft, flat surface.
2. Insert socket assembly part (B) into lamp base (A), gently twist to
tighten and pull any excess cord from the lamp base.
3. Place harp (D) onto saddle (C).
4. To assemble shade, place the support rod into bottom ring as
shown in diagram. Place the other end of the support into the top
ring. Repeat this step with the other rods.
5.Place shade (E) onto harp(D) and fasten with finial (F).
6. Use with one
150 watt max
standard bulb or 3-way CFL
equivalent. Do not exceed maximum wattage as specified on the
socket label.
Indoor use only in dry location.
Unplug to change bulb or clean the lamp.
Remove cellophane cover from the shade before use.
Keep cellophane out of reach of children and pets
21
Penn
Plaza
Suite
909
New
York,NY
10001
Tel:
(212)
736
4440
Fax:
(212)
736
4806
www.adessohome.com
