adept technology Cobra Dual, Процедура настройки, Страница: 8 / 12

Adept Technology, Inc.
8 Dual Adept Cobra Robot Configuation Procedure, Rev A
Figure 9. Device Module Selection
11.Enter 6 at the “Enter selection number” prompt. The following will be displayed.
Figure 10. Module Confirmation
12.Enter Y at the “Are you sure you want to select this module (Y/N)?” prompt.
13.Enter N at the “Do you want robot number 3 (Y/N)?” prompt. The above information will
now be saved to the system.
14.Press Enter to continue.
15.Select option 0 “Return to main menu.”
16.Select option 0 “Exit to system monitor.”
17.Disconnect the controller from AdeptWindows, and power cycle both robots and the
SmartController.
18.After boot up, a screen similar to the screen shown in Figure 2 on page 5 will be
displayed. Go to Section 4.0 to continue the setup process.