ADEMCO VISTA-100, Руководство по установке

Страница: 40 / 208

–30–
Check-Out Procedure For Hard-Wired Zones
After installation of all hard-wired zones is complete,
each partition of the security
system should be checked as follows:
1. Make certain that all devices and sensors connected to the hard-wired zones
are not in a faulted state. Doors and windows with contacts should be closed,
PIRs should be covered (use a cloth to mask them temporarily if necessary).
2. With all hard-wired zones intact, the Alpha keypads connected to the system
should display:
DI S ARME D
RE ADY TO ARM.
If the following is displayed,
DI S ARME D P r e s s
✴
to s how fa ul ts
press the [
✴
] key to display the faulted zone(s). Restore any faulted zone(s)
as necessary (also make sure that you have connected a 2000 ohm EOL
resistor across the terminals of unused zones). When the
DISARMED...READY TO ARM message is displayed, you can proceed to the
next step.
4. Fault and then restore every contact or sensor on each zone individually to
ensure that it is being monitored by the system. Each time a zone is faulted,
the keypads in the partition to which the zone is assigned should display the
number of the faulted zone. Tripping fire and panic zones will cause
external sounders to sound and may trigger the dialer. When each zone
is restored, the READY TO ARM message should appear again.
If a zone or zones are not displayed at the correct partition's keypad(s), check
both keypad and zone programming to verify the correct partition assignment.
5. When you get the proper displays on the keypad(s), the hard-wired zones in
the system are functioning properly.
6. Power down and continue to the next section.
www.PDF-Zoo.com
firealarmresources.com