background image

ADEMCO 5802WXT Supervised Miniature 

Transmitter  –  Installation Instructions 

 

General Information

 

The ADEMCO 5802WXT is a wireless transmitter that may be worn around 
the neck, on a wrist band or as an apparel clip that may also may be mounted 
to a desk, dresser, etc. (necklace, band, and clip supplied). Pressing and 
holding the transmitter button for two seconds sends a signal to the control 
receiver. The 5802WXT is intended for use only with wireless alarm systems 
that support 5800 Series devices. 

The transmitter is supervised, i.e., it automatically sends a message to the 
control receiver that includes battery status information every 70-90 minutes.  

This transmitter can be programmed as any zone type response (e.g., 
Emergency Panics, Relay Action, etc.).

 

 

Programming the Serial Number

 

The 5802WXT has a unique identification code (serial number) permanently 
assigned during manufacture. 

You must “enroll” the transmitter’s serial number and loop number during 
system programming. The 5802WXT may be defined as Input Type “RF” 
(supervised RF, for an hourly check-in; 

do not 

take out of range) or “UR” 

(Unsupervised RF). Its loop number is “1.” See the control unit’s Installation 
Instructions for further details regarding programming. When installation is 
complete, verify operation from desired location(s).

 

 

Battery Replacement

 

The 5802WXT is powered by a long-life Lithium battery that may be replaced 
when a low battery is eventually indicated by the control unit. 

NOTE: 

When replacing the battery, wait a minimum of 30 seconds prior to installing the 

new battery. 

NOTE: 

 Although water-resistant, please do not immerse in water at a depth below 

10cm for more than 1 hour. 

 

1. Remove 4 screws and lift off 

cover. 

2. Using a small flat-blade 

screwdriver remove old battery. 

3. Insert new battery by placing 

new battery under the gold tab 
and then pressing down.  
Ensure the POS + side of 
battery is face up after 
installation. 

4. Align cover and attach with 4 

screws. 

5

8

02

W

XT-001-V0

BATTERY

SCRE

W

S (4) TYP.

 

5

8

02

W

XT-002-V0

INSERT BATTERY

UNDER GOLD TAB

AND PRESS DO

W

N

 

Отзывы: