ADDER ePowerSwitch 8XS, Руководство пользователя

Страница: 5 / 22

Page | 3
ePowerSwitch 8XS
SAFETY INSTRUCTIONS: To be read before use!
NOTE
•
The ePowerSwitch devices can only be installed by qualified people with the following installation
and use instructions. The manufacturer disclaims all responsibility in case of a bad utilization of
the ePowerSwitch devices and particularly any use with equipments that may cause personal
injury or material damage.
•
This equipment is designed to be installed on a dedicated circuit that must have a circuit breaker
or fuse protection.
•
The electrical power sockets used to plug the power cords of the ePowerSwitch devices must be
close to the ePowerSwitch devices and easily accessible.
•
Check that the power cords, plugs and sockets are in good condition.
•
The ePowerSwitch devices can only be connected to three-wire 230 VAC (50-60Hz) sockets.
•
Always plug the ePowerSwitch devices into properly grounded power sockets (two poles plus
ground).
•
Never exceed 10 Amp total load for each group of 4 power outlets of an ePowerSwitch device.
•
The ePowerSwitch devices are intended for indoor use only. Do NOT install them in an area
where excessive moisture or heat is present.
•
Always disconnect the 2 (two) power cords of the ePowerSwitch device if you want to intervene
on the ePowerSwitch device or on the equipment powered from the ePowerSwitch device.
•
The power outlets of the ePowerSwitch devices are not circuit breakers! If you want to intervene
on equipments connected to an ePowerSwitch device you must disconnect these equipments
from the ePowerSwitch device.
•
Do NOT attempt to disassemble the ePowerSwitch devices, they contain potentially hazardous
voltages.
•
The ePowerSwitch devices contain no user serviceable parts and repairs are to be performed by
factory trained service personnel only.
•
Always use a shielded cable for the Ethernet connection.