7351 Series Digital Multimeter Operation Manual
5.9.6 MAX/MIN Calculation
5-29
5.9.6
MAX/MIN Calculation
1. Function
1. This function calculates the maximum, minimum, and average values while the
MAX/MIN calculation is performed.
2. The following calculations are performed at the same time in the MAX/MIN cal-
culation.
• Maximum value (MAX)
• Minimum value (MIN)
• Average value (AVE)
• Measurement count
3. All measurement data except for overload (OL) and calculation error data can be
used for the calculation.
4. If BEEP is set to ON, the buzzer sounds when the MAX or MIN value is renewed.
However, although the displayed value is not changed, the buzzer may sound.
This is because the resolution of measurement value is higher than the resolution
of the displayed value.
2. Setting the calculation
The operation is switched as shown in below by selecting MX/MN in
.
NOTE:
Refer to “4. MAX/MIN calculation value display function during the measurement” in this section.
MENU
MENU
..3.. CALC
MX/MN
OFF/ON/MAX/MIN
MAX MIN
Turn off
MAX MIN
Turn on
Canceling the calculation
The MAX and MIN lamps turn off.
Performing the calculation
Any one of the following conditions is displayed.
(NOTE)
• The MAX and MIN lamps turn on.
• The MAX lamp blinks.
• The MIN lamp blinks.