ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 88 / 236

4601 I-V Meter Operation Manual
4.2.10 MENU Key (Parameter Setting)
4-8
F) EXT.SIGNAL Sets the external signal-related parameters.
1) Operate Control Selects the signal for the BNC connector OPERATE IN/OUT on the rear
panel.
Standby In Sets Standby when the signal level changes from LO to HI.
OPR/STBY In Sets Standby when the signal level changes from LO to HI.
Sets Operate when the signal level changes from HI to LO.
OPR/SUS In Sets Suspend when the signal level changes from LO to HI.
Sets Operate when the signal level changes from HI to LO.
Operate Out Outputs LO in the Operate status.
Outputs HI in the Standby or Suspend status.
2) Comp./Sync. Sel Selects the signal for the BNC connector COMPLETE OUT/SYNC OUT on
the rear panel.
Sync. Out Outputs the Sync. Out signal.
Complete Out Outputs the Complete Out signal.
3) Signal Width Selects the signal width of Complete Out/Sync Out between 10

s and 100

s.
G) PARAMETER Loads or saves the setting parameters.
1) Load Loads the setting parameters saved in the non-volatile memory.
from User-0 Loads the parameters from the non-volatile memory,
User-0.
from User-1 Loads the parameters from the non-volatile memory,
User-1.
from User-2 Loads the parameters from the non-volatile memory,
User-2.
from User-3 Loads the parameters from the non-volatile memory,
User-3.
Default Loads the factory default values as setting parameters.
2) Save Saves the setting parameters to the non-volatile memory.
to User-0 Saves the current parameters to the non-volatile memory,
User-0.
to User-1 Saves the current parameters to the non-volatile memory,
User-1.
to User-2 Saves the current parameters to the non-volatile memory,
User-2.
to User-3 Saves the current parameters to the non-volatile memory,
User-3.
Default to All Saves the factory default values to the non-volatile
memory, User-0 to User-3.