ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 87 / 236

4601 I-V Meter Operation Manual
4.2.10 MENU Key (Parameter Setting)
4-7
Fixed level sweep:
1) Bias Value Sets the bias value.
2) Level Value Sets the level value.
3) Sample Count Sets the sampling count.
Memory sweep:
1) Bias Value Sets the bias value.
2) Sweep Address Sets the start address and the stop address.
3) Memory Data Set Sets the source value at each memory address.
4) Mem. Save/Clear Saves or clears the memory data.
D) TIME Sets the time parameters.
1) Integ. Time Sets the integration time IT.
2) Source Delay Sets the source delay time Tds.
3) Measure Delay Sets the measurement delay time Td.
4) Period Sets the sampling interval in the DC source mode or the step time Tp in the
sweep source mode.
5) Hold Time Sets the hold time Th in the sweep source mode.
6) Trigger Delay Sets the delay time Tdr between the external trigger (TRIGGER IN signal) and
the sweep start or between the external trigger and the next step value output.
E) MEASURE Sets the measurement-related parameters.
1) Memory Recall Recalls and displays data from the measurement data memory.
2) Memory Store Selects whether measured data is stored to the measurement data memory or
not (ON or OFF) in the DC source mode.
Memory store is always set to ON in the sweep source mode.
3) Memory Clear Clears data in the measurement data memory.
4) Measure Zero Measures necessary internal zero points to cancel zero point errors in mea-
sured values. Zero measurement should be executed after warm up.
5) Measure Switch Switches measurement ON or OFF.
6) Pt/Ad Select Selects the sensor to be connected to the temperature measurement connector.
7) RTD Sets the resistance bulb standard.
Pt100 Pt100 (compliant with JIS C1604-1997/IEC 60751)
JPt100 JPt100 (compliant with JIS C1604-1981)
8) Temp. Unit Sets the temperature unit.

C,

F or K