ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 55 / 236

4601 I-V Meter Operation Manual
3.2 DC Source Mode
3-3
3.2 DC Source Mode
3.2.1 Setting and Outputting Voltage Source Value
1. Setting the voltage source value using the numeric keypad
This section describes the procedure of setting the source value using the numeric keypad and out-
putting it.
Each procedure should be started with the initial state (factory default settings). If the 4601 is not in
the initial state, initialize the 4601 referring to Section 3.5.2, "Restoring to Factory Default Settings"
previousely.
Output voltage of +10.000 V according to the following procedure:
Operating procedure
Press to select the optimal range setting.
The FIT key goes ON, which indicates the optimal range setting status.
Press to set the source value to 10 V.
Example display
Press to output the source value (Operate). While the source value is output, the OPERATE
key lights up.
When the Operate status is set, current measurement (Im), voltage measurement (Vm) and reference
cell current measurement (Ir) start.
The current measurement (Im) range is the same as the current limit range.
The voltage measurement (Vm) range is the same as the voltage source range.
The reference cell current measurement range is the setting range.
1
2
3 4
1
2
3