ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 221 / 236

4601 I-V Meter Operation Manual
A.2 Error Message List
A-3
A.2 Error Message List
If an error occurs when using the 4601, an error code accompanied by an error message appears on the screen.
The contents are explained in the following:
Error codes marked with are generated by the self test.
Table A-2 Error Message List (1 of 3)
Error
code
Description Message
-102 Command syntax error Syntax error
-113 Unsupported command Undefined header
-200 Execution error (Command currently not executable) Execution error
-222 Out-of-range input value setting or insufficient parameter Data out of range
-313 Calibration data is lost. Calibration memory lost
-314 Data saved by the *SAV command is lost. Save/recall memory lost
-315 Saved parameters are lost. Configuration memory lost
-330 Self test error Self-test failed
-350 Error queue overflow Queue overflow
+001 ROM check SUM error ROM check sum error
+002 Display section RAM test/communication error Panel memory error
+003 VFD module communication error VFD module error
+004 RAM read/write error RAM read/write failed
+005 Analog section communication error Communication error
+008 FLASH memory write error FLASH memory error
+009 Sweep RAM read/write RAM-2 read/write failed
+012 Calibration data check SUM error CAL data sum error
+013 Parameter check SUM error Parameter sum error
+015 No output unit mounted No Output unit
+130 Internal SCI communication start error Sub CPU does not respond
+140 Internal SCI communication error (Receiving an improper code) Sub CPU comm. error
+141 Internal SCI communication error (Receiving another code during response) Internal comm. error
+150 USB communication error Illegal packet received
+101 Analog section RST signal test error ADRST Signal Check
+102 Analog section TRIG signal test error ADTRG Signal Check
+111 ADC1 operation IR1-IR2 ratio test error ADC1 Ratio 1 to 2
+112 ADC1 operation IR2-IR3 ratio test error ADC1 Ratio 2 to 3
+113 ADC1 operation IR3-IR4 ratio test error ADC1 Ratio 3 to 4
+114 ADC1 operation IR4-IR5 ratio test error ADC1 Ratio 4 to 5