ADC ECOWASH-MP2, Руководство пользователя и по обслуживанию, Страница: 19 / 34

113688- 1 19
Programme: 2
WHITES/COLOUREDS 60°C
Wash 60°C
Filling...
While the program is running the next keys on the control
panel may be pressed, activating different functions in
each case:
PAUSE key: the program sotps, it is paused. The screen
displays the message:
Programme: 2
WHITES/COLOUREDS 60°C
Wash 60°C
Pause on...
For the program to continue, press the START key.
For safety reasons, the program can not be paused
while in the spin cycle, and therefore the PAUSE key is
disabled during the spin cycles.
ADVANCE (>>) key: Use the ADVANCE key to go
directly to the next phase.
After a few seconds, the program continues, starting
the next phase, unless the phase being carried out when
ADVANCE was pushed was the last one, in which case
the program will end.
If the ADVANCE key is pressed while the machine is
spinning, as the drum is braking the following message
is displayed (the braking time is approximately 1.5
minutes depending on the model of washing machine,
please wait and do not try to open the door):
Programme: 2
WHITES/COLOUREDS 60°C
Spin 500rpm
Braking...
STOP key: when this key is pressed, the following
message is displayed:
P2:WHITES/COLOUREDS
60°C
Spin 900rpm
End program?
SEE INPUTS
SEE OUTPUTS
SETTINGS
TRUE VALUES
To end the program, press ENTER; to continue the
program press ESC.
INFO key (advanced) While the machine is running, use
the INFO key to enter the parameters in use at that
moment; the different options are displayed on the
following figure:
The active inputs and outputs are displayed in real time,
together with the true values and the program settings.
2.5 Program end
The program can finish in several ways:
■
Normal end: the program finishes when all its
phases have been carried out.
■
Pressing the STOP key: from any point in the
program, pressing the STOP key and then the
ENTER key.
■
Pressing the ADVANCE key: at any point of the
program, pressing the ADVANCE key repeatedly
or holding it continuously the end can be
reached. As in the previous case, if a spinning
process was being carried out, first the braking
of the drum will be allowed during a few seconds
before replaying the ADVANCE key again.
When a program finishes, before the door can be
opened the unwinding of the clothes is carried out during
30 seconds, and the screen displays the following
message:
After 30 seconds, a message appears on the screen
accompanied by an acoustic signal, indicating that the
program has ended and that the door can be opened:
Programme: 2
WHITES/COLOUREDS 60°C
Spin 500rpm
Unwinding...
Now, the acoustic signal can be stopped by pressing
PAUSE or by opening the door.
Programme: 2
WHITES/COLOUREDS 60°C
End of program
Open door...