ADC ECOWASH-MP2, Руководство пользователя и по обслуживанию, Страница: 18 / 34

18 113688- 1
2.2 Operation
This machine has been designed to wash or treat most
materials. Its use for other purposes than those given
is considered as undue and dangerous.
The machine should be loaded with the nominal load,
smaller or bigger loads should be avoided.
Clothes should not be washed in sacks or cloth bags. If
this is absolutely necessary, make sure the machine is
loaded to the nominal load to avoid possible unbalanced
loads.
Canvas, waterproof items, mops, carpets or rugs should
not be spun.
The machine is controlled using a programmable
microprocessor able to adapt to the needs of each user.
There are 16 programs which can NOT be modified,
you may create up to 99 programs to meet your needs.
For further details, please see the sections
Programming (page 68) and Standardised Programs
(page 68).
The machine has an intelligent controller to control the
water temperature. If hot water is available it should be
connected. The machine adjusts the different water
inputs to maintain the programed temperature.
It has intelligent control for spin cycle management. The
washing machine controls any unbalanced loads and
manages the spin to ensure a good spin, reducing noise
and extending the useful life of wearable components,
thus significantly reducing fatigue in the mechanical
components.
2.3 Selecting a program
When the washer turns on, the last program carried out
appears on the screen, indicating its number and name,
as well as its main characteristics. For example, if
program number one was selected:
The first line on the screen indicates the program
number (1) and its name (WHITES 90 °C) is on the
second line. The functions of each key are given in the
last lines.
2.4 Program execution
In order to carry out a wash program, the following steps
should be followed:
¾
Put dirty clothes in washing machine drum.
¾
Close washing machine door.
¾
Add detergent.
Programme: 1
WHITES 90°C
Programme: 2
WHITES/COLOUREDS 60°C
Prewash 30°C
Filling...
¾
Select desired program.
¾
Press the START key.
Once the program has started, information relating to
the ongoing program’s status and function is shown on
the screen. For example:
The third line indicates the ongoing phase, in this case
a pre-wash. The fourth line shows the operation in
process at that instant, in the example, filling.
When the fill has finished and the heating starts (if
optional heating is installed), this is indicated on the
screen, as can be observed in the following figure:
After finishing heating the water, the washing time starts,
and the time remaining to complete the prewash cycle
is displayed on the screen, as can be observed in the
following figure:
Then the following phase begins, in this case the wash
phase, as can be observed in the following figure:
When the phase finishes, the drainage is performed,
indicated on the screen, as can be observed in the
following figure:
Programme: 2
WHITES/COLOUREDS 60°C
Prewash 30°C
Heating...
Programme: 2
WHITES/COLOUREDS 60°C
Prewash 30°C
Time remaining 4 min
Programme: 2
WHITES/COLOUREDS 60°C
Prewash 30°C
Draining...