ADC AVIDIA SWD4573I1, Руководство пользователя, Страница: 220 / 658

Configuring SPVCs
194 Avidia System Configuration and Management User Manual
Deleting SPVCs
From the appropriate
::spvc=>
prompt, type the delete command in the following format,
then press .
delete <slot.port> <vpi> <vci>
Information Description
Admin Status The SPVC administrative status. Options:
• Up—activated
•
Down—deactivated
Operation Status The SPVC operational status. Options:
• In Progress—attempting to connect
•
Connected—operational
•
Retries Exhausted—not operational
Source Slot The channel card slot and port (format slot.port).
Source VPI The VPI of the VCC between the CPE and the line card.
Source VCI The VCI of the VCC between the CPE and the line card.
Destination Address The ATM address of the destination ATM end system.
Source Tx Traffic Index The traffic descriptor profile index assigned to the SPVC
transmitted traffic.
Source Rx Traffic Index The traffic descriptor profile index assigned to the SPVC
received traffic.
Last Release Cause The reason the SPVC was last disabled. This displays as a
numeric code. See
“SPVC Last Release Cause Codes” on
page 607 for code definitions.
Retry Failures The number of times the system has attempted to restart
non-operational SPVC but failed.
Retry Interval The number of seconds the system waits before attempting
to re-establish the SPVC after a failed call attempt (range: 0 to
3600).
Retry Limit The maximum allowable number of unsuccessful call setup
attempts (range: 0 to 65535).
ENTER