ADB EURODIM TWIN TECH, Руководство по установке

Страница: 20 / 166

EURODIM TWIN TECH
www.adblighting.com Installation manual - Page 18
Version 1.2
Installation of TI
– Measurement device
1.) Remove the Bus-Bar protection (2
Screws).
2.) Install the TI-Holder (long metal
plate)
– Direction depends if the
cable entry is from the top or bottom
of cabinet.
3.) Connect Phase and Ground Cable to
the Bus-Bar with suitable screws.
4.) Bring the NEUTRAL (blue) cable
through the TI (the TI can be opened
for easier installation.
5.) Connect the NEUTRAL to the bus
bar.
6.) Place the Bus-Bar protection back in
the cabinet
– and attach with the two
screws.
Mounting of the TI for supply cable entry
from the top of the cabinet Mounting of the TI for supply cable entry
from the bottom of the cabinet
5.4 Software Installation
The black lines are ETHERNET connections between the EURODIM Twin Tech, Switch and
PC running the TTD Management Software. This software must only be installed one time.
At the same time a lighting control desk (which must support ArtNET communications
protocol) may be connected to the ETHERNET Switch. To simplify the image the control
desk has not been included in the drawing. Both the PC running TTD Management Software
and the lighting control desk (e.g. ADB LIBERTY, FREEDOM or MENTOR desks) may
operate simultaneously and there is no influence, since both systems work with different
protocols. Alternatively the control desk may be connected to one of the DMX inputs of the
EURODIM Twin Tech cabinet. (Instead of using ArtNET protocol). The ETHERNET switch is
connected with suitable communication cables (e.g. CAT5) to handle the dimmer information
as well as the ArtNET communication.