ADB Safegate RELIANCE Intelligent Lighting Platform III, Руководство пользователя

Страница: 87 / 118

4.10.2 Testing a SRU — Segment Assignment
1. Configure the remote with lucDMC. Refer to Configuring a SRU — Default Parameters .
2. Switch on the regulator to a set point level between 2.8 A and 6.6 A.
The group information for the lamps of the modules concerned can be found in the RELIANCE IL configuration Table.
If there is already a RELIANCE IL configuration with groups in the lucDMC, the next step “Segment (group) formation in
the lucDMC” must be omitted.
If you have a RFID handheld reader available for RELIANCE IL, you can scan the RFID tag labelto see the segment
information.
Check the lamp feedback and the status of the light to verify whether the group switching command has been executed
correctly.
3. Right-click on the lamp and assign the lamp to a segment by selecting add to a segment from the drop-down menu if
not set by default to 1).
Figure 62: Drop-down menu — switch a segment
4. Drag and drop the lamp to the segment you want to assign the lamp to if you have integrated a RELIANCE IL SRU
Remote. For SRU the dialog box change property — group opens. Type in the number of the segment you want to
assign the lamp to.
Figure 63: Dialogue box — add a new segment ID
5. Hit the apply button to save your changes.
6. Repeat the steps of the lamp test for the segment feedback.
UM-5005, Rev. 004, 2020/08/06 75
Copyright
©
ADB SAFEGATE, All Rights Reserved