ADB Safegate RELIANCE Intelligent Lighting Platform III, Руководство пользователя

Страница: 55 / 118

3.3 Getting started with a new SRU
DANGER
Use of the equipment in ways other than described in the catalog leaflet and the manual may result in personal injury,
death, or property and equipment damage. Use this equipment only as described in the manual.
Before you can operate new RELIANCE IL SRU within a series circuit configuration is required.
First connect the remote to a regulator capable to be used with the RELIANCE IL system and configure it using the lucDMC
software tool. For configuration instructions see Configuring a SRU — Default Parameters .
It is required to make the following settings:
1. Serial number: is a unique identifier for a remote within a system
2. Remote address: is a unique identifier for a remote within a series circuit
3. Segment for lamp 1: Lamp 1 has to be assigned to a specific segment.
4. Segment for lamp 2: Using Remotes SRU102 or SRU112, lamp 2 has to be assigned to another segment.
Note
For special purposes you can also assign a lamp to two different segments.
5. Maximum of remotes per series circuit: This setting is specially essential for series circuits containing SRU102 or SRU112.
Note
Make sure that the value is the same for all remotes in the series circuit as well as in the Central Unit of the
respective regulator.
For use in series circuits with LED lights, additional settings to be made for the remotes include:
LED load: 'on' must be activated.
Note
•
Special settings can be set by using "RAW telegram".
•
Refer to RELIANCE IL SRU Remote CU Commands in lucDMC for instructions related the the settings made using
'RAW telegrams'
UM-5005, Rev. 004, 2020/08/06 43
Copyright
©
ADB SAFEGATE, All Rights Reserved