ADB Safegate EREL, Руководство пользователя

Страница: 33 / 50

4. Install the new arctic kit screws (C). See § Screws and torques (torque).
5. Connect the cable with 4 poles to connector (D).
Note
There are one or two additional connector(s) for the connection of the LED MCPCB and for service and diagnostic.
Those connectors have 5 poles.
6. Install the optical cover. See § Part replacement - optical cover .
7. Install the complete optical head. See § Part replacement - complete optical head .
4.3.6 Part replacement - body
Parts: See § Exploded view .
•
Body
•
Optical cover gasket
•
LED MCPCB screws
•
Body gasket
•
Cooling block gasket
Tools:
•
Screwdriver, Torx T25
Remove
1. Remove the complete optical head. See § Part replacement - complete optical head .
2. Put the complete optical head on a clean surface.
3. Make sure that the complete optical head is earthed. Connect the earth to the connector (A): PE. The PCBs will discharge.
4. Remove the optical cover. See §
Part replacement - optical cover .
5. Remove the optical kit. See § Part replacement - optical kit .
6. Remove the cooling block. See § Part replacement - cooling block .
AM.03.120e, Rev. 3.4, 2019/03/29 27
Copyright
©
ADB Safegate, All Rights Reserved