Adaptive
Technologies
Group
1635
E.
Burnett
Street
|
Signal
Hill,
CA
90755
USA
Ph:
562.424.1100
|
Fax:
562.424.3520
ALWAYS
INSTALL
SAFETY
CABLES
WARNING:
Mounting and/or suspension loudspeakers requires experienced
professionals. Improperly installed loudspeakers can result in property damage,
personal injury and/or liability to the installing contractor
Installation Guide
SAS-200-24-
32” LINE ARRAY WALL MOUNT
The SAS-500-WM line array wall mount is a load rated universal wall arm
system for mounting loudspeakers weighting up to 500lb/228 kg to walls &
other vertical structures. This heavy duty stainless steel wall arm mount is
rated for extreme outdoor environment.
NOTE: Screws, bolts, and washers to attach line array wall mount to
structure are not included.
Step 1:
Locate and mark the desired installation area. If needed mark the wall with
the mounting holes of the SAS-500-WM using the top and bottom center
holes.
Step 2:
Attach the line array wall mount to the wood structure using the
appropriate hardware, such as lag screws for wood structure and ½”
dia. anchor bolts for concrete walls. Make sure that the wall is strong
enough to carry the 5 times the load of the speaker and wall arm.
Consult with your local hardware specialist for the proper hardware to
use (Figure 1).
Note to installers
Due to the wide variety of wall structures, materials and mounting methods,
these instructions assume that the installing contractor will exercise proper
judgment in selecting the mounting area and hardware.
As a guide, the installation, when complete should be capable of
supporting 5 to 10 times the actual applied load. Also, always use a
backup safety system such as a safety cable.
To assure a trouble-free installation, read and follow these
instructions carefully before beginning. If you have doubts about
the integrity of the structure you are mounting to or you are not
sure about the proper hardware to use, consult a structural
and/or hardware specialist.
Be sure that all the following items are included in this kit before
proceeding:
1 pc 32” Wall Mount Assembly 2 pcs ½-13 x 3.5” Eyebolt
1 pc 27” Cross Arm Tube 3 pcs ½”-13 Nylock Nut
6 pcs ½” Flat Washer 3 pcs ½” Split Lock Washer
2 pcs 2” sq rib Endcap 2 pcs 3/8” Shackle
1 pc .5 IDx1.5 OD Nylon Washer 1 pc ½-13 x 5.5” Hex Cap Bolt
2 pcs 3/8”-16x1.25 Eyebolt 4 pcs 3/8” Flat Washer
2 pcs 3/8-16 Nylock Nut
1 pc Instruction Sheet
SAS-500-WM
