Adaptec Snap Server 700i Series, Руководство пользователя

Страница: 43 / 236

Step 2: Configuring the iSCSI Storage Appliance
Chapter 4 Setting Up Your iSCSI Storage Appliance and IP SAN 37
2
Under Network settings, enter the values you prepared in “Before You Begin” on
page 34.
Enter a name for the iSCSI Storage Appliance and the network domain to which
the iSCSI Storage Appliance belongs.
Enter a gateway name or IP address, or accept the default gateway.
Enter IP addresses for up to three domain name servers, if required.
3
( Optional ) Under CLI settings, change the Administrator and Operator passwords
from their defaults. (By default, both passwords are ‘admin’.)
4
Click
Next
, then set values for each Ethernet port on your iSCSI Storage
Appliance, using the tabs at the top of the window to ensure that all ports are
configured. Use static IP addresses for each port, and ensure that DHCP is
deselected .
Note
By default, Ethernet Port 0 is the management port and is used by the
Management Service to communicate with your iSCSI Storage Appliances; it is
also an iSCSI port. You can configure Ethernet Port 0 as a management port only
by selecting that option in the Port Type drop-down menu.
5
Click
Next
. By default, the current date and time is used for the iSCSI Storage
Appliance. You can choose to manually set the date and time values, if required.
Note
The Adaptec OnTarget operating system does not automatically adjust the
time setting on your iSCSI Storage Appliance to accommodate Daylight Saving
Time. However, the appliance uses the time setting for event timestamps only;
the appliance time setting is not used for job schedules or other functions.
6
Click
Next
, confirm the settings for this iSCSI Storage Appliance, then click
Apply
.
Deselect
DHCP
Click tabs to
view other
ports