6-4
Adaptec Ultra320 SCSI Cards User’s Guide
Changing Boot Controllers
If you want to reconnect your bootable hard disk drive from the
SCSI controller to the HostRAID controller, you must:
1
Start Windows NT 4.0 and install the driver from the Adaptec
HostRAID Driver Set disk. See
Windows NT 4.0 is Already Installed on page 6-3
2
Shut down Windows NT 4.0 and turn off your system.
3
Switch the bootable hard disk drive from the old SCSI controller
to the HostRAID controller.
4
Power on your system.
Windows NT 4.0 Installation and Configuration
Notes
If Windows NT 4.0 Setup Hangs
During Windows NT 4.0 installation, the system may hang while
the Windows NT 4.0 Setup floppy disk is being used to copy the
device driver. A workaround is to start from a DOS boot disk,
create a DOS partition on the array using
fdisk
, then install
Windows NT 4.0 on the array.
Windows NT 4.0 Disk Administrator
When creating a new array on a system running under
Windows NT 4.0, the array is not listed as usable in the
Windows NT 4.0 Disk Administrator until it is initialized. This is
normal Windows NT 4.0 functionality.
U320 UG.book Page 4 Tuesday, September 23, 2003 1:47 PM
