Vehicle Exterior
14.
Check the Wheel Bolt Torque
14.1. Make sure the EPB is applied.
14.2. Remove all of the wheel bolt caps with the wheel bolt cap removal tool.
NOTES
Do not
use the wheel bolt cap removal tool in the tool kit; it is strictly for client use. Instead, use T/N 07AAC-
T6NA100 that came with your required special tools shipment.
•
Position the tool onto the cap, and push on both sides until they click into place.
•
Gently pull off the cap.
14.3. Using a flex-head torque wrench and deep 17 mm socket, carefully torque each wheel bolt to
125 lb-ft (170 N·m)
.
To avoid damage, make sure there is enough clearance between the fender and your torque wrench when
turning it.
14.4. When you are done, install all of the caps.
Vehicle Exterior
15.
Set the Tire Pressures
To prevent flat spots during vehicle shipping, the tires are overinflated. Adjust the tire pressures to
32 psi
. If you are in a
cold climate region, make sure the tires are at the same temperature as the outside air before adjusting the pressures;
otherwise, the Low Tire Pressure/TPMS indicator may come on in cold weather.
NOTE
There is no spare tire. This vehicle comes with a tire repair kit behind the tool kit.
Page
15
of
25
