Radar Sensor
The radar sensor cover is located
under the Acura emblem in the front
grille. If the radar sensor cover is
covered with mud, dirt, dead leaves,
wet snow, etc., or if you put a sticker
on it, the CMBS will automatically
shut off, and the CMBS indicator on
the instrument panel will come on.
You will also see a
‘‘
CHECK CMBS
RADAR SENSOR
’’
message on the
multi-information display for about
5 seconds.
Always keep the radar sensor cover
clean. If it gets dirty, clean it with
water or a mild detergent. Never use
chemical solvents or polishing
powder.
There are three bolts on the sides of
the radar sensor. Do not tamper with
these bolts, or you may cause the
system to malfunction.
If either of these parts receives a
strong impact, to turn off the system,
press and hold the CMBS off switch
until you hear a beep, and have your
vehicle checked by a dealer. If the
front grille ever needs to be repaired,
consult a dealer first.
If the radar sensor cover or the radar
sensor ever needs to be removed,
take your vehicle to a dealer.
When the CMBS is on, the radar sensor
constantly scans for vehicles ahead of
you. This means that driving on a road
with a few or no vehicles could cause a
CHECK CMBS RADAR SENSOR
message to appear on the multi-
information display. This is normal and
not a cause for concern.
RADAR SENSOR COVER
BOLTS
(Do not tamper)
CONTINUED
Collision Mitigation Braking System
™
(CMBS
™
)
499
Driving
2010 ZDX