ActronAir Easyconnect Serene, Инструкция по установке и настройке

Страница: 11 / 24

Installation Guide Easyconnect App
Installation Guide - Easyconnect App
Document: 9590-4008
Ver. 6 230501
11
05.03. Smart Device (Easyconnect)
NOTES
• Ensure that the Android or iOS device can be automatically connected to
the Wi-Fi network - you can adjust this in your phone settings.
• To configure Easyconnect, a wireless remote controller must be used - a
disposable control is supplied in the kit to setup the Wi-Fi.
There are two ways to configure the network connection. This may be done
via Bluetooth, scanning for available devices or by manual selection of the
device.
05.03.01. Bluetooth Scanning
Ensure that Bluetooth on the mobile device is ON
1. Tap on + Add Device . 2. Power the Air conditioner off from
the power supply for 15 seconds,
then back on again.
3. Within 8 minutes of power being
reset, press the LED button on the
remote control 7 times (within 10
seconds) - this will initiate access
point mode and allow your phone to
link with the Easyconnect app setup
process.
4. Tap on Scan for nearby devices . 5. Wait smart devices to find, then click
to add it.
Note: If no device is found, go straight to manual configuration
Section 06.02, step 2.