Activa 12200R Cabrio, Инструкция по сборке и эксплуатации

Страница: 18 / 22

Art. Nr.: 12200R Cabrio
Page 18 of 22
EN
Light the grill with a match:
1. Proceed as indicated.
2. Light a long match and insert it into the ignition hole on the right side of the firebox.
3. Press and turn the control knob of the selected burner to MAX.
4. Set a temperature between MIN and MAX with the control knob.
5. After the first burner ignites, ignite the other burners with the corresponding knobs.
Press the knob and turn it to MAX to ignite.The first burner ignites the nearby burner
by skipping the flame.
6. If the burner will not light after several attempts, this may indicate a problem in the
gas supply. Close the gas supply on the unit as well as on the gas cylinder. Do not
use the appliance until you have found the cause of the problem.
Attention!
Before first use, preheat the unit on maximum heat for about 10 minutes to allow the paint
smell of the new parts to dissipate
.
Attention:
When the lid is open, the grill can be operated with the small and the large flame!
When the lid is closed, the grill may only be operated with the small flame!
Grilling tips!
For smaller grilling quantities, it is recommended to use only one half of the grill.
With the lid closed during grilling, you will achieve the maximum heat development, as well
as a very juicy taste of the grilled food.
14. Information on commercial use
According to BGV D34 (VBG21) and TRF 96, a hose rupture safety device
according to DIN 30 693 and a safety pressure reducer according to DIN 589
must be used when the device is used commercially. Hose rupture
protection and safety pressure regulator are not included in the scope of
delivery.
15. Malfunctions
Should a malfunction occur despite the use of quality materials as well as individual parts ap-
proved by the German Technical and Scientific Association for Gas and Water (Deutscher
Verein des Gas- und Wasserfaches e.V.), please observe the following guidelines: