ActionTec Plug n' Play Voice/Fax Modem V.90 ISA, Руководство пользователя

Страница: 27 / 73

27
sources. The modem needs one IRQ and one COM Port in order to function. (Read
your computer user’s manual for information on how to invoke and use the BIOS
setup).
Inside your computer’s BIOS Setup, find the Plug-N-Play configuration. This can be
found within a section titled “Advanced”, “PNP/PCI Configuration”, or “Plug and
Play Configuration” depending on the BIOS Manufacturer. Next, from the informa-
tion you noted in Step 2, find the interrupt selection for the IRQ your modem is
using (some BIOS don’t allow individual selection of interrupts to ISA, Plug-N-Play,
or PCI). You want to set this to a Plug-N-Play setting. This can be called ICU/PCI,
ISA, or PNP depending on your BIOS version and manufacturer. Do not set this
interrupt to “PCI” only or to “Legacy ISA”.
If you do not have any free interrupts available, you will have to disable some unused
function of your computer system. If you are using a PS/2 style mouse, you probably
can spare one of your internal COM Ports. To disable a COM Port, find the BIOS
Setup section for “Integrated Peripherals”. Locate the serial port settings and disable
an unused port that has nothing connected to it (usually serial port 2.) This should
free one IRQ for your modem to use. You may also have to disable the COM Port in
Windows 95.
Under some situations, you will find that freeing an interrupt does not solve your
installation difficulties. This could be due to another peripheral device stealing the
interrupt you just provided.
Certain full-featured sound cards require three IRQs to support all their functions.
This situation requires that you remove your sound card, make an interrupt avail-
able, install the modem and verify its operation, and then reinstall the sound card.
This procedure may also work for sound cards that have lost their sound after the
modem has been installed or if the modem will not install in a system with a sound
card.
Common Problems
No Dialtone Error
Make sure you have connected the phone cable into the right connector on the back
of the modem. See Figure 7: Connecting Devices.
You may have too many devices connected to the phone line. Remove all other equip-
ment.
Your modem may not recognize overseas dialtone. Use the AT Command ATX0
(See Appendix B: AT Commands) to have the modem ignore the dialtone before
dialing.