www.acti.com
Hardware Manual
13
Installing the Camera Using the Flush
Mount
This section describes the procedures in mounting the covert or pinhole covert camera on a
flat surface, such as wall or ceiling, with the use of the bundled flush mount. This installation
requires access to the back of the surface. The main unit can be installed apart from where the
camera is mounted, like in a secured area or separate room.
NOTE:
The following pictures are for reference only, actual lens differs depending on the
camera model.
Before installation, consider the following:
Requires access to the back of the surface
Supported surface thickness: 1 ~ 10 mm
Camera cable length: 12 meters
Mounting location of camera and the main unit can be separate
Step 1: Install the Flush Mount
1.
Attach the bundled Flush Mount drill template sticker on the target installation surface.
2.
Mark the screw holes and the perimerter where to mount the flush mount.
3.
Drill the lens hole.
4.
After drilling the lens hole, remove the drill template.
