www.acti.com
2
Using the tips in following chapters you will be able to achieve following:
VMS
Configure MD
Preset mode via
VMS
Able to get stream by
VMS while camera is
in MD Preset mode
Can operate ePTZ and
presets manually by
VMS at the same time
NVR 2.3
No
Yes
Yes
NVR 3.0
No
Yes
No
SNVR 1.02.12
No
Yes
No
Using NVR 2.3
Only get stream by VMS
Use the following steps:
1. Web Configurator/Setup: Set the camera to MD Preset Mode
2. Web Configurator/Live: Open PTZ window and set Preset Points
3. Web Configurator/Setup: Open Motion Detection page and set MD regions and priorities.
4. NVR ActiveSetup: Add KCM-3911 to NVR. MD Preset Mode will be detected, but is not
configurable.
5. NVR ActiveMonitor: Watch the live view from KCM-3911 running on MD Preset mode
Get stream by VMS and operate ePTZ and presets manually by VMS at the same time
Use the following steps:
1. Web Configurator/Setup: Set the camera to MD Preset Mode
2. Web Configurator/Live: Open PTZ window and set Preset Points (the locations can be
random at this point, but the amount of preset points has to be correct)
3. Web Configurator/Setup: Open Motion Detection page and set MD regions and priorities.
4. NVR ActiveSetup: Add KCM-3911 to NVR. MD Preset Mode will be detected, but is not
configurable.
5. NVR ActiveSetup: Enable to the PTZ function under PTZ tab using
“ACTi” protocol.
6. Set the preset points under
“PTZ Preset” tab again. This time, use the true locations of
each preset point. Remember to press
“Apply” to save them.
7. NVR ActiveMonitor: Watch the live view from KCM-3911 running on MD Preset mode. At
the same time, you may anytime control ePTZ manually, or force camera to go to any
preset point you like on the PTZ panel of NVR ActiveMonitor.
