ACTi E31A, Руководство по оборудованию

Страница: 14 / 37

www.acti.com
Hardware Manual
14
Step 4: Waterproof and Connect the Cable
The camera and the pre-
installed network cable, “pigtail”, are resistant to salt, water, weak acid,
alcohol, oil, grease and other common solvents. If the camera will be installed indoors, simply
connect the network side cable to the camera Ethernet port. Then, skip to Step 5: Connect
the Cable on page 15.
However, if the camera will be installed outdoors, ensure that the cable connection and the
network side cable itself are also protected from different environmental factors. Check the
type of Ethernet port that came with the camera and follow the applicable procedures to
waterproof the connection. Select one of the following cabling options applicable to the
connector that came with the camera.
Cabling Options
Round-Shaped
Connector
Square-Shaped
Connector
Using the Round-Shaped Connector with
Cable Gland

Applicable when using an exterior-grade
Ethernet cable to connect to the camera.

Bundled cable gland provides complete
waterproof solution.

See Using the Round-Shaped Connector
with Cable Gland on page 16.
Yes No
Using the Waterproof Tape

Applicable when using an exterior-grade
Ethernet cable to connect to the camera.

Easiest and simplest waterproof solution for
the most common installation needs.

See Using the Waterproof Tape on page
19.
Yes Yes
Using the Bundled Conduit Gland

Applicable when a flexible conduit is needed
to house the Ethernet cable required in some
installation environments.

A flexible conduit (trade size ½”) is required,
purchased seperately.

See Using the Bundled Conduit Gland on
page 20.
Yes Yes