ACT DX 240, Руководство пользователя, Страница: 4 / 9

4
4. Once both ends of the cable are plugged in properly, the second row of LEDs will
illuminate according to the corresponding LEDs in the top row.
5. Read the results of the LED display for the pin configuration status of the tested
cable. If you fail to read the results the first time in Auto mode, you may wait for
the second LED scan, or simply switch to Manual mode for pin by pin testing. In
Manual mode, pressing the square "Test" button will advance testing to the next
pin.
Note: Make sure the battery power is sufficient. Insufficient battery
power will lead to dimmed LEDs and incorrect results.
3.2 RJ11 Modular Cable Test
1. Please follow directions for the UTP/STP Cable Test and refer to the diagram
below for the correct LED pin out display
3.3 Coaxial Cable Test
1. Plug the two included BNC adapter cables on both RJ45 jacks.
2. Then connect the BNC cable to each end of the BNC adapter cables
3. Slide power switch on. The upper row of LEDs will start to scan in sequence if the
Auto/Manual button is set on "Auto" mode. The LED for pin 1 will light up if the
button is in "Manual" mode.
4. Switch back and forth from Auto or Manual scanning mode by pressing the
Auto/Manual button on the side of the master testing unit.
5. Once both ends of the cable are plugged in properly, the second row of LEDs will
illuminate according to the corresponding LEDs in the top row.
6. Read the results of the LED display for the pin configuration status of the tested
cable. If you fail to read the results the first time in Auto mode, you may wait for
the second LED scan, or simply switch to Manual mode for pin by pin testing. In