Configuring ACTpro200
1.
Connect up the ACTpro200 to the readers and the ACT2000/3000 as per the
installation diagram.
2.
*Remember
to connect the terminals marked DOORS on the ACTpro200 to
the controller together.
3.
Connect up the door locks to the fused outputs.
Remember
to connect the
supplied varistors across the door lock terminals.
4.
Set the dipswitch on the ACTpro200 to the desired address. The doors are
numbered in sequence, so if the dipswitch address is set to 7, then door 1 will
report as 7 and door 2 will report as 8.
5.
Remember
to enable communications with the doors from the
ACT2000/3000. Go to Installer Menu->Communications->Remote Doors.
6.
Connect up both 7AHr batteries.
7.
Test the ACTpro200 by pressing the buttons above the batteries. This will
connect the batteries to the system and allow the ACTpro200 to operate
8.
Check that ACTpro200 powers up.
9.
Check that both the green battery LEDs are on steady.
10.
The red LED in the centre of the board should flash rapidly indicating
communications with the controller.
11.
Close the cabinet lid over.
12.
Apply mains power.
1
13.
Check that the controller reports the ACTpro200 as online. Ensure there are no
faults reported on the controller display.
14.
For ACTWinPro users, make sure the
Mains Fault
box is ticked for the
ACTpro200 doors.
Download the database.
15.
ACTWinPro should display the doors as blue icons.
1
16.
Check that cards/PIN codes grant access and open the doors.
1
Use ACTWinPro 2.2 or later with the ACTpro200.
Always
connect Battery 1 to the ACTpro200. Battery 2 is not required if nothing is
powered from Output 2. Monitoring of Battery 2 may be disabled by setting
Dipswitch 3 to ON.
www.accesscontrol.ie +353 1 466 2570
All manuals and user guides at all-guides.com
all-guides.com