Model TT231-0600
Two-Wire RTD Transmitter w/USB
Acromag, Inc. Tel: 248-295-0880
- 15 - http://www.acromag.com
- 15 -
http://www.acromag.com
Configuration
Note that without a device already
connected via USB, the Device
Status field indicates
“Disconnected”.
After you connect USB, the first
step to begin Configuration is to
select the device to connect to
using the scroll window of the
Device Name field. Use the scroll
bar to click on and select a
transmitter from this list in order
to open it for reconfiguration (use
the serial number to discern a
particular transmitter). Then click
the “Open” button to connect to
the selected device.
If your transmitter was already
connected via USB when you
booted this software, your screen
will look more like the screen at
right, where the software has
already initiated a connection to
the transmitter for you (see Device
Connect area and note that Device
Status indicates “Connected”).
Note that the software
automatically opened the
connection with the transmitter
and “Read Complete” is indicated
in the message bar at the bottom
of the screen. Additionally, most
fields and controls are not faded
out and await your input.
After executing the Acromag Configuration software for this model, a screen similar
to the following will appear if you have not already connected to your transmitter
via USB (note some fields are faded out under these conditions):