MiniPuck Model ST132-06x0 Two-Wire TC/mV Transmitter
________________________________________________________________________________
______________________________________________________________________________________
Acromag, Inc. Tel:248-295-0880 Fax:248-624-9234 Email:
9
USB Interface
•
Scans for connected transmitters and allows you to selectively open
communications with them.
•
Devices Found: Connected transmitters are listed in this pull-down
select menu.
Click to highlight a transmitter and then click the “Open”
button to open communications with it.
•
Open/Close Button: Click this button to open or close communication
with the selected transmitter listed in the Devices Found field.
•
Displays the model number (Product Name), Manufacturer, and Serial
Number of the connected/selected transmitter.
The software automatically scans for connected transmitters when it is
booted. You can select a connected transmitter and open communications
with it from the Device Found pull-down menu. The connected/selected
transmitter’s ID info (Product Name/serial, Manufacturer, & Serial Number)
is also displayed. Device connection status messages are also indicated in
the System Message Window at the bottom of the screen.
Configuration Area
•
Input Type:
Set the Input Type, J, K, T, E, R, S, B, N, or ±100mV.
•
Break Control:
Set the break detection direction (Up or Down).
•
Filter Control:
Set the level of filtering to be applied to the input signal.
•
CJC Control:
Select if the CJC is used (On or Off).
•
I/O Scaling:
Select the input range endpoints to scale to the 4 to 20mA
output range endpoints. You can optionally set this up for a reverse-
acting output by swapping the signals.
CONFIGURATION
SOFTWARE
Introduction
This transmitter can only be
configured and calibrated via
its Configuration Software and
a USB connection to your PC
or laptop. The configuration
software can be downloaded
free of charge from our web
site at
This software is also included
on a CDROM bundled with the
Configuration Kit ST13C-SIP
(see Accessories section).
For this model, look for
program ST132-ST133
Config.exe. The software is
compatible with XP or later
versions of the Windows
operating system.
The configuration software
screen for this model is shown
at left. The configuration
screen is divided into five
sections as follows: USB
Interface, Configuration, Test,
Calibration, and the Message
Bar and controls at the bottom
of the screen. Additionally,
there is a Reset button, a
button to restore the unit to the
factory default state, and a
button to exit the program. A
short description of each of
these groups follows. For a
detailed explanation, see
Configuration Step-by-Step in
the Technical Reference
section of this manual.
HELP
– You can press F1 for
Help on a selected or
highlighted field or control.
You can also click the [?]
button in the upper-right hand
corner of the screen and then
click to point to a field or
control to get a Help message
pertaining to the item you
pointed to.