MiniPuck Model ST132-06x0 Two-Wire TC/mV Transmitter
_________________________________________________________________________________
______________________________________________________________________________________
Acromag, Inc. Tel: 248-295-0880 Email:
10
Use the controls of the Configuration section to select an input type, the
break detent, filter level, CJC on/off, and input range scaling.
Test Input Area
•
Polling Toggle & Input Display Field:
This button will toggle polling of
the input on/off and display the input level in the adjacent field.
Calibration Area (See Configuration Step-by-Step for Procedure)
•
Input:
This section calibrates the selected input range.
•
Output:
This section calibrates the 4 to 20mA output.
•
TRef:
This section calibrates the cold-junction temperature reference
for cold junction compensation of the T/C.
•
Restore Factory Calibration Button:
This button will restore only the
original factory calibration to the unit. Note that this will not reset any of
the configuration settings.
This section is used to calibrate the input, output, and CJC temperature
sensor of the unit. Instructions on how to calibrate the unit is detailed in the
Configuration Step-by-Step section of the Technical Reference portion of
this manual.
Message Bar
•
Displays the Fault Status of your transmitter input signal.
•
Displays prompt instructions during calibration.
The system message bar at the bottom of the screen will display & repeat
prompt instructions as you step through calibration. It also displays
diagnostic messages (see Configuration Step-by-Step section for specific
messages).
Other Options:
•
Reset ST13x:
This button will reset the ST132 unit.
•
Restore to Out of Box Condition:
This button will restore
ALL
configuration settings and calibration to their original factory settings.
You can click the “Restore Factory Settings” button if you ever mis calibrate
or misconfigure a transmitter in such a way that its operation appears
erratic.
CONFIGURATION
SOFTWARE
Introduction
You
can click on “File” in the
upper left-hand corner to open
a previously saved file, save
your own file, or print out your
configuration.
You can refer to the
Configuration Step-by-Step
section of the Technical
Reference portion of this
manual for a more detailed
description of every control
described here.