Acromag microBlox uBSP-P-1, Руководство пользователя, Страница: 7 / 32

microBlox® Signal Splitter Model uBSP-P-1
Acromag, Inc. Tel: 248-295-0880 - 7 -
http://www.acromag.com
- 7 - https://www.acromag.com
DIN Rail Mounting & Removal
Refer to the following figure for attaching and removing the carrier from the DIN rail.
A plastic spring DIN clip is located on the bottom side at each end. You can pry the
DIN clip back with a screwdriver along the bottom to release the unit and lift it from
the rail.
To attach the carrier to T-type DIN rail, position the top groove of the DIN Clip along
the rail and push the bottom inward to snap it into place on the DIN rail.
To remove it from the DIN rail, first disconnect any I/O wiring from its terminals.
While holding the carrier secure, insert a screwdriver along the bottom edge of the
carrier into the loop of the DIN rail clip and use it as a lever to force the DIN rail clip
down, while pulling the bottom of the carrier outward until it disengages from the
rail. Then tilt the carrier upward and lift it from the rail.