microBlox® Signal Splitter
Model uBSP-P-1
Acromag, Inc. Tel: 248-295-0880
- 31 -
http://www.acromag.com
- 31 -
https://www.acromag.com
Enclosure & Physical
Board is held in place by a plastic
panel holder with an integrated DIN
clip
for mounting on 35mm “T
-
type” DIN rail.
Dimensions
: Width = 75.2mm (2.96inches along rail), Height = 72.0mm
(2.83inches perpendicular to DIN rail), Depth = 36mm (1.42inches vertical w/o
modules). Refer to Mechanical Dimensions drawing. Note that the plug-in
module extends approximately 1.4” above the
splitter panel (a splitter with a
module will have a maximum depth of 71mm or 2.8inches).
Input, Output, and Power Connectors:
Fixed type terminal blocks rated for
12A/250V; AWG #28-16, stranded or solid copper wire.
Carrier Material:
Self-extinguishing polyamide, UL94 V-0 rated, color light gray
(black end caps). General purpose NEMA Type 1 enclosure.
Circuit Board:
Military grade fire-retardant epoxy glass per IPC-4101/98.
DIN-Rail Mounting:
Unit is normally mounted to 35x15mm, T-type DIN rails.
Refer to the DIN Rail Mounting & Removal section for more details.
Unit Weight:
0.25 pounds (0.12 Kg).
Environmental
Limits represent the minimum requirements of the applicable standard, but this
product has typically been tested to comply with higher standards in some cases.
Operating Temperature:
-40
C to +75
C (-40
F to +158
F).
Storage Temperature:
-40
C to +85
C (-40
F to +185
F).
Relative Humidity:
5 to 95%, non-condensing.
Isolation
: Input/field isolation is provided by the plug-in uB module sold
separately. Host/USB/AUX, uB input, power, and output circuits are all isolated
from each other for common-mode voltages up to 250VAC, or 354V DC off DC
power ground, on a continuous basis (will withstand 1500VAC dielectric strength
test for one minute without breakdown). This complies with test requirements
of ANSI/ISA-82.01-1988 for voltage rating specified.
Installation Category:
Suitable for installation in a Pollution Degree 2
environment with an Installation Category (Over-Voltage Category) II rating per
IEC 1010-1 (1909).
Shock & Vibration Immunity:
Conforms to: IEC 60068-2-6: 10-500 Hz, 4G, 2
Hours/axis, for sinusoidal vibration; IEC 60068-2-64: 10-500 Hz, 4G-rms, 2
Hours/axis, for random vibration, and IEC 60068-2-27: 25G, 11ms half-sine, 18
shocks at 6 orientations, for mechanical shock.
Electromagnetic Compatibility (EMC)
Minimum Immunity per BS EN 61000-6-1:
1)
Electrostatic Discharge Immunity (ESD), per IEC 61000-4-2.
2)
Radiated Field Immunity (RFI), per IEC 61000-4-3.
3)
Electrical Fast Transient Immunity (EFT), per IEC 61000-4-4.
4)
Surge Immunity, per IEC 61000-4-5.
5)
Conducted RF Immunity (CRFI), per IEC 61000-4-6.
This is a Class B Product with Emissions per BS EN 61000-6-3:
1)
Enclosure Port, per CISPR 16.
2)
Low Voltage AC Mains Port, per CISPR 14, 16.