OPERATION
Angle Head
Tool Body
Multi Function
Button
Start Lever
Cable
Connection
Square/
Hex Drive
3
1. Connect tool cable to the iEC controller and the tool:
The tool cable has curved alignment tabs and slots
built into the connectors at each end to ensure proper
alignment and connection with the tool and controller.
Make sure that power is not turned on at the controller
before making any connections
. Align the female connec-
tor on the cable with the male connector on the tool and insert
the cable onto the tool, then slide the connector nut onto the
threads on the cable and turn clockwise until hand-tight.
Align the male connector tab on the other end of the tool
cable with the female slot on the controller and insert the
cable into the connector, then slide the metal outer cover
onto the connection threads on the controller and turn clock-
wise until hand-tight.
2. Multifunction Button Operation:
The tool will flash all LED lights three times when power is
first turned on at the controller. After the controller finishes
initializing and displays a target toque value, the multifunction
button (MFB) is used to toggle the tool from clockwise mode
(FWD) to counter-clockwise operation mode (REV). The MFB
is the small button opposite the trigger.
The tool will initially start in clockwise mode and will have no
LED lights turned on. If the trigger is pressed, the tool will
turn on the blue LED meaning the tightening operation is
underway. Pressing the MFB will cause the tool to flash yel-
low and red LED lights. Pressing the MFB again will switch
the tool back FWD mode and will indicate this with no LED
lights turned on.
3. Start Lever Operation:
To start the tool, depress the start lever. Blue LED lights will
be displayed while tightening a bolt. The tool will stop auto-
matically when it senses its target torque value or if no torque
is sensed in a specified time period. After a cycle is complete,
the tool will display green LED lights for a success, or red
LED lights for failure to reach torque/angle.
A complete tool system consists of the following items:
Controller
Power cord
Tool
Tool Cable
Light Ring Light Assignment
The Buzzer and Multi-Function Button are programmable in the
DSP Menu of ToolWare.
Light Color
Meaning
Green Solid
OK
Red Flashing
Torque Low
Red Solid
Torque High
Yellow Flashing Angle Low
Yellow Solid
Angle High
Blue Solid
Tool In-Cycle/Tool Armed
Blue Flashing
P-Set Change thru MFB
All On Flashing
Tool in Disassembly
Buzzer
Bad Assembly/Tool in Disassembly/Power Up
