Acoustic Signature TA-700, Инструкция по эксплуатации, Страница: 5 / 8

5. Prepare adjusting the cartridge
Before we start aligning the cartridge we we need to pre adjust
the Tracking force and the height of the tonearm. Tracking force
will be adjusted by turning the counter weight forward (more
weight) or backward (for less weight). Search the manual of your
cartridge for the right value and adjust it by using a weight scale
(not provided). After you have done the setup of the Tracking force
please tighten the 3 small screws to fix the position of the weight.
.............................................
5.1 Prepare adjusting the cartridge
Adjust the arm height with cartridge fitted, is either level or slightly
low at the front end. You can do this by opening the red marked
screw with the provided allen key. Open it carefully adjust the nee-
ded height and tighten the screw softly. Check if height is ok - if
not redo the adjustment. Be aware the when opening the screw
the arm might fall down!
.........................................................................
6. Adjusting the cartridge
This is done by using the provided adjustment template. Take the
template and assemble it as shown and place it on the platter.
Some units also come pre assembled.
6.1 Adjusting the cartridge
Use the plastic (showed in the left picture) piece and place on top
of the 2 metall pillars facing the Alu center pin downwards. Move
the arm forward or backward so the center pin is exactly fitting into
the small drilled marking on top of the arm. tighten the arm if this
position is exaclty matching. This ensures your template is in the
correct angle for adjusting the cartridge and the distance of the
arm related to the middle of the platter is
correct.
............................. ....................................