Page 10 / 22
User Manual ACO5000
Front panel description
Power supply module
Power Drive module
D-sub 9 poles connector for the specific user
interface TL5
USB Port
dedicated as service port to:
Program the drive(s)
Up-date the firmware
Commission the installation
Testing and debugging
Internally connected to the drive(s)
Note: Not to be used to operate the equipment
in production.
7-segments display
shows the current status of
drive, used as fault indicator too.
PROGRAM:
a service
push button
used to
upgrade the firmware via the USB port. Pressing
this button at power ON or under power for more
than 5 sec will initiate a point-to-point connection.
This port is used to set the # of the drive(s) and
their PROFIBUS address.
PROFIBUS
D-sub 9 poles connector.
This field bus is an option, not to be retrofit in the
field. Ask for the specific user manual.
SENSOR input
for speed feedback.
TTL encoder or magneto-resistive sensor
Removable
CONTROL TERMINALS
See “Description of the control terminals X2”
