ACOEM Met One Instruments GAS-1060, Руководство пользователя

Страница: 66 / 164

Serinus 60 User Manual 3.0
Page 66
WAN
Below is an example of Airodis setup for a WAN network. Ensure the IP address is set the same as on
the remote modem/router.
Figure 16 – WAN Network Set-Up (Airodis)
4.4 Digital/Analog Communication
The 25 Pin analog/digital port on the rear of the instrument sends and receives analog/digital signals
to other devices. These signals are commonly used to activate gas calibrators or for warning alarms.
4.4.1 Analog Outputs
The instrument is equipped with one to three analog outputs that can be set to provide either
voltage (0-5V, 0.25-5V, 0.5-5V, 0-10V) or current (0-20, 2-20, 4-20 mA). The analog outputs are tied
to specific instrument measurements, depending on the instrument type.
For 0-10V analog output operation, set the output type to current and move the jumpers (JP3) on the
rear panel PCA to 0-10V (refer to Figure 17).
Table 4 – Analog Outputs
Analyser Output 1 Output 2 Output 3
S10 O
3
N/A N/A
S30 CO CO
2
[optional] N/A
S40 NO NO
X
NO
2
S44 NO NH
3
NO
2