GENERAL INFORMATION
Power supply unit with a built-in video splitter for up to 3 monitors (MPRO 4, 3.5, 7 or GLASS-PRO-7), dedicated
to COMO / Familio PRO system. Typically used in single family, two or three family houses, to supply the entire Typically
used in single family, two or three family construction, to supply the entire video intercom system. The power supply units
can be combined with each other and used also in multi-family houses. It can also be used to connect UPRO audio
receivers (for PRO and PRO-A systems). The power supply unit is also compatible with other ACO audio/video systems. It
can be connected with RJ-45 connectors or, alternatively, with ARK screw connectors.
Features:
- connection of 3 monitors at a distance of up to 70 m (cat. 5e)
- main input from a panel or another ACO standard source
- direct connectivity of a COMO/ Familio PRO panel at a distance of up to 100 m (cat. 5e, with no E-lock supply)
- E-lock supply availability (only with ARK screw connectors)
- built-in, active video amplifiers
- compatible with other ACO video systems
- connectivity with RJ-45 or ARK screw connectors
- DIN rail mounting
TECHNICAL PARAMETERS
•
Power supply voltage
100 – 240 VAC 1.0 A 50 / 60 Hz
•
Output voltage
15 VDC ± 5%
•
Allowable load current
3 A
•
Mounting
DIN rail 35 mm or surface mounted
•
Width 6 DIN modules (106.3 mm)
•
Installation type (Video version)
digital PRO / PV system: twisted pair cat. 5e or 6
•
Installation type (Audio version)
digital PRO-A system: 3 wires
•
Outputs
ARK screw connectors (disconnectable): 15 V DC, GND,
Line, 3 x video (differential); 3 x RJ45 to connect monitors
•
Inputs
ARK screw connectors (disconnectable): 230 V (PE, L, N),
Video IN (differential); 1 x RJ45 to connect COMO/Familio
PRO panel (with no E-lock supply)
SYSTEM ASSEMBLY AND CONNECTION
ATTENTION! For proper performance and safety of use, the power supply unit should be connected to
230 V mains with a suitable three-core cable, absolutely connecting the PE terminal. The connection to the 230 V
mains must be made by a qualified electrician - the voltages there are dangerous for health and life!
The power supply unit is intended for mounting on a 35 mm DIN rail or surface mounting. Connections should be
made with dedicated plugs to screw and RJ45 connectors as shown in Fig. 1.1 and 1.2.
Fig. 1.1. Outputs at the power supply unit's top
Fig. 1.2. Outputs at the power supply unit's bottom
The mains supply shall be connected to a 230 V AC plug, paying attention to the correct connections of the phase and the
neutral conductors.