Installation
30/ 100
Oleolift-C
Cover plate similar to 4034-1
IMPORTANT
Arrange the openings of the cover plates as
shown below:
Cover plates with openings: 1x Ø 800
and 1x Ø 625
Cover plates with openings: 2x Ø 800
Î
Position the cover plate in the centre
above the container, place it vertically
and let it slide on. Press carefully if there
is any canting.
Complete weight,
Chapter 7.1.2 “Characteristic Data”.
Supporting rings
Standard supporting rings can be installed between the cover and the cover plate to
adjust to the upper level of the terrain on site. Supporting rings with construction heights
from 70 to 210 mm can be optionally purchased from ACO.
ATTENTION
Produce a maximum of 600 mm with a inside width of 625 mm.
Specifications:
■
The mortar joint shall not be less than 1 cm or more than 3 cm.
■
Use MG III mortar per DIN 1053. Alternatively, use non-shrinking shaft-grouting mortar,
e.g. Ebralit or equivalent. In doing so, the manufacturer's processing instructions must
be complied with.
■
Establishing a permanently liquid-tight connection.