Fig. 3 Maximum line lengths.
Volume settings.
The call volume of the module is pre-set (according to fig. 4), users may change the volume when connected to the monitor in the following way:
- adjust the sensitivity of the panel microphone using the "
MIC
" potentiometer ,
- adjust the panel volume level using the "
SPK
" potentiometer.
Fig. 4 Volume control potentiometers.
As these values are set, use the "
BALANCE
" potentiometer to determine the position of the excitation points (squeak) in the loudspeaker and set the
potentiometer halfway between these points. The volume of sounds emitted by the module is set using the "
BEEP
" potentiometer.
Module installation.
Mount the module in the desired place (such as front panel with call buttons, letterbox, etc.) by sticking it with the double-sided tape provided in
the set. It is important to note the holes of the loudspeaker and microphone in the mounting location: they must coincide with the holes in the module. If
necessary, the module must be drilled in place of mounting. Ensure the correct mounting direction of the module: the loudspeaker must be at the top to
maintain the best possible water tightness. Angles are also included in the kit, which can be used to press the module against the mounting surface.
Optional MOD-10NBP modules are mounted in close proximity to the main module.
The antenna of the proximity key fob reader should be mounted at a distance from the main module that is allowed by the cable included in the
kid and in such a place that it is not obscured by the metal objects. The antenna can only read key fobs correctly through non-metallic materials (such as
plastic) and should be mounted (built in) behind elements made of such materials. Before installing the antenna, verify the operation and range by trial
and error. The range of the antenna is mainly effected by metal elements (also those in the vicinity) and the distance between the antenna to the proximity
key fob.
The microphone is mounted as far away from the main module as the provided cable allows and as far away from the speaker as possible. It is
absolutely necessary to keep the microphone tight between the mounting front (the rubber band included must be pressed firmly against the mounting
front or the microphone must be otherwise isolated tightly from the main unit) - in case of a leak, feedback may occur in the audio track during conversation
(squeaking / buzzing).
The main module, the antenna and the microphone should be mounted in such a way that adverse weather conditions, especially water, have
the least possible impact.
Fig. 5 Module dimensions
RULES FOR STORING WASTE ELECTRICAL EQUIPMENT
Waste electrical equipment must not be disposed of with other waste. It should be stored in places designated for this purpose. For this purpose, please
contact the responsible institutions or companies involved in waste recycling. - Directive 2002/96/EC of 27.01.2003
ACO Sp. z o.o. sp. komandytowa, 62-002 Suchy Las, ul. Diamentowa 7, tel./ fax 61 843 93 72
IU0121enVA.1950